How to Clean a GE Deep Fill Washing Machine

Why Cleaning Your GE Deep Fill Washing Machine is Important

Regularly cleaning your GE Deep Fill washing machine is crucial to maintaining its performance and prolonging its lifespan. Over time, dirt, grime, and detergent residue can build up inside the machine, leading to unpleasant odors, mold growth, and even potential damage to your clothes. By following a few simple steps, you can ensure that your washing machine stays clean and efficient, providing you with fresh and clean laundry every time.

Gather the Necessary Supplies

Before you start cleaning your GE Deep Fill washing machine, make sure you have all the required supplies on hand. These include:

• Vinegar

• Baking soda

• A microfiber cloth or sponge

• A toothbrush

• Hot water

Step-by-Step Cleaning Process

1. Clean the Exterior

Begin by wiping down the exterior of the washing machine with a damp microfiber cloth or sponge. Pay special attention to any visible stains or spills. If necessary, use a mild detergent to remove stubborn marks. Remember to also clean the control panel and knobs, being careful not to get them too wet.

2. Clean the Dispenser and Filter

Remove the detergent dispenser drawer and soak it in a mixture of hot water and vinegar. Use a toothbrush to scrub away any residue or mold. Rinse the dispenser thoroughly and let it dry before reinserting it into the washing machine. Additionally, check the filter located at the bottom of the machine. Remove any debris or lint buildup and clean it with warm water.

3. Run a Cleaning Cycle

To thoroughly clean the interior of your GE Deep Fill washing machine, run a cleaning cycle with hot water and vinegar. Fill the drum with hot water, add two cups of vinegar, and let the machine run for a full cycle. This will help remove any remaining detergent residue and eliminate odors.

4. Clean the Drum

After running the cleaning cycle, inspect the drum for any remaining dirt or stains. If needed, mix a paste of baking soda and water and apply it to the affected areas. Let it sit for a few minutes, then scrub the drum with a toothbrush. Finally, wipe the drum clean with a damp cloth.

5. Prevent Future Buildup

To prevent future buildup and maintain a clean washing machine, consider the following tips:

• Use the recommended amount of detergent for each load.

• Leave the door open after each use to allow the drum to dry completely.

• Regularly clean the rubber seal and door gasket to prevent mold growth.

• Wipe down the interior of the machine, including the drum and door, after each use.